Some involve deeper research areas. And because most students have just contacted the die, they do not have a deep understanding of the working principle and processing characteristics of the die, and adopt research teaching The method of letting this part of self-study will inevitably cause a lot of difficulties to it, so the author adopts question-based and case-based teaching methods. Specific to teaching, various teaching methods such as discussion teaching, interactive teaching, task-driven teaching, case teaching, cooperative teaching, etc. In the closed-book exams used in the past, students memorized the contents of the exams by rote, and they could not really reflect the learning effect of the students, nor could they reflect the students’ true abilities. The course "Punching Process and Die Design" can be divided into three parts, punching die design, bending die design and drawing die design.
The teaching organization is arranged before the lecture, and the teacher arranges the students into groups. Team members can communicate with each other, discuss Plastic mould with each other, and cooperate with each other. Including the process of teaching implementation process schedule, teaching organization, curriculum assessment and other content. The process of teaching implementation process table according to the teaching tasks and teaching objectives, overall planning of classroom lectures, extracurricular layout research reports, project exercises, student group discussions and other content. The design of the bending die and the drawing die are two parts. Among them, the punching die design part has a high degree of standardization of the die, and the die design is relatively regular, which is suitable for the traditional teaching method. Teachers first propose topics, and then guide students to go to the library to find relevant materials, analyze and summarize, and finally form a report. Teachers should change the traditional one-time assessment model for life-long assessment, implement full-course evaluation combining in-class teaching and extra-curricular learning, adopt a variety of examination methods, and promote examination system reform.
In the design part of the bending mold, the structural design of the bending mold is simple, but in the bending process, the calculation of the size of the bending blank and the determination of the bending springback value are difficult. After completing the research https://www.pet-mould.com report or project training, let each student separately present the research report, and put forward the problems encountered in the research process and the solutions. The selection and design of stamping die structure cultivate the basic ability of students in die design, so that students have a comprehensive understanding and understanding of die.
The teaching organization is arranged before the lecture, and the teacher arranges the students into groups. Team members can communicate with each other, discuss Plastic mould with each other, and cooperate with each other. Including the process of teaching implementation process schedule, teaching organization, curriculum assessment and other content. The process of teaching implementation process table according to the teaching tasks and teaching objectives, overall planning of classroom lectures, extracurricular layout research reports, project exercises, student group discussions and other content. The design of the bending die and the drawing die are two parts. Among them, the punching die design part has a high degree of standardization of the die, and the die design is relatively regular, which is suitable for the traditional teaching method. Teachers first propose topics, and then guide students to go to the library to find relevant materials, analyze and summarize, and finally form a report. Teachers should change the traditional one-time assessment model for life-long assessment, implement full-course evaluation combining in-class teaching and extra-curricular learning, adopt a variety of examination methods, and promote examination system reform.
In the design part of the bending mold, the structural design of the bending mold is simple, but in the bending process, the calculation of the size of the bending blank and the determination of the bending springback value are difficult. After completing the research https://www.pet-mould.com report or project training, let each student separately present the research report, and put forward the problems encountered in the research process and the solutions. The selection and design of stamping die structure cultivate the basic ability of students in die design, so that students have a comprehensive understanding and understanding of die.
コメント